Transmitter HR Multi PC

Brand: HR Matic
Frequency: Multifrequency. It is applied through the machine.
Switch: It has no
Battery: 23A 12v
Buttons: 4
Programming: By PC machine without cable

pdf Programming instructions

Description

With the MULTI PC control we can copy 433.92 and 868 MHz fixed code and evolutionary controls such as Keeloq, V2, Nice Flor or GO.

 

Information

With the MULTI PC control we can copy 433.92 and 868 MHz fixed code and evolutionary controls such as Keeloq, V2, Nice Flor or GO. The fixed code can be recorded by proximity and without machine and for the evolutionary we need the machine HR COMPACT PC. You can record a different knob on each button or assign each knob the required number of buttons.

Deleting the data of a button:

Before copying by proximity the data of another control, the button in which they are going to be recorded must be erased, to erase it it is necessary to do the following steps:

1. Press buttons 1 and 2 at the same time, the led will produce two flashes.
2. Release one of the buttons and make three keystrokes on the button to be erased.
3. The led will flash quickly indicating that the data has been erased.

When pressed a button erased, the led indicates it producing a single flash.

Notes on erasing a button’s data:
If you are going to copy by proximity and without a machine a fixed code command and 868 Mhz it will be necessary to configure for 868 Mhz the button in which the command is going to be recorded since it defaults to 433 Mhz. To do this, in step 1, pushbuttons 1 and 2 will be kept pressed until a flash occurs after the initial two and then the pushbutton in which the three pulses are made will be ready for 868 Mhz.

For the copy of evolutionary controls with machine only it is necessary to have erased the data of any button, which will be the one that must be pressed when the command is recorded but the data will be recorded in the button or buttons marked in the program regardless of whether Data is deleted or not.